cdi fin

mojo · Posted: May 13, 2009 3:36 pm Post subject: cdi fin

i just spent 20$ on a fin and it didn't even come with a screw. what size screw will i need for my simplex whenever it gets here?

BB · Backside 180 Joined: 28 Jul 2006 Posts: 1706

Go to a hardware store and take the fin...

mojo · Posted: May 13, 2009 3:39 pm Post subject:

good call. but it doesnt just have to do w/ the fin. it also has to do w/ the board. i might not use fins at all, but i got 1 so i can see which way i like it more.

mojo · Posted: May 13, 2009 3:39 pm Post subject:

good call. but it doesnt just have to do w/ the fin. it also has to do w/ the board. i might not use fins at all, but i got 1 so i can see which way i like it more.

uidzero · Kickflip Joined: 01 Jun 2005 Posts: 3839 City: Casselberry

that's kinda fvcked up

mojo · Posted: May 13, 2009 3:45 pm Post subject:

i emailed them just letting them know it's a bummer. they sell a multi size screw/washer set for 9.99 c'mon if i go to the hardware store it'll cost me all of 18 cents

itch · Posted: May 13, 2009 6:31 pm Post subject:

Mojo don't freak I will call Lyle and get you a screw pm me you r real name and addie.
ITCH

mojo · Posted: May 13, 2009 6:34 pm Post subject:

no worries man. i didn't even notice at first. i was just stoked to have a fin that would fit my board, and then i went and looked in the trash to see if i forgot to get the hardware. i probably have one that will work laying around my toolbox. it's just i've been on boards for a long time and usually have bought smaller or different fins and they have always cost the same, but come with washers and screws. thanks though. like i said, i was just bummed.

gatorskater · Posted: May 13, 2009 6:42 pm Post subject:

I have fins on my integ, I bought a round head screw that fits flush with the top deck of the board so you don't have to use a washer, you don't even notice the screw there. Picked em up at ACE.

SleuCrew · Posted: May 13, 2009 7:15 pm Post subject:

The bolts your looking for are 1/4 - 20, ask any local hardware store for that and they can point you in the right direction.

However the length of the bolts you need vary depending on what board you are putting them on.