help reshaping omen rails

TexasBlazed · Frontside 180 Joined: 13 Nov 2008 Posts: 384 City: DFW

any help?

t-rex · Backside 180 Joined: 24 Jun 2007 Posts: 2007 City: Denver

do a search... there's lots of stuff about reshaping rails on this site

TWG · Kickflip Joined: 25 Sep 2006 Posts: 3258

just drag it across the pavement until you get the shape you want

nickl011 · Posted: Nov 14, 2008 7:46 pm Post subject:

220 git paper, round in the middle, sharp near the tips.

TexasBlazed · Frontside 180 Joined: 13 Nov 2008 Posts: 384 City: DFW

thanks bro.
easy to screw it up?

SkateWake772 · Ollie Joined: 08 Nov 2008 Posts: 92 City: Orlando

is the reshaping becuase you want a different feel or is it bashed up?

TexasBlazed · Frontside 180 Joined: 13 Nov 2008 Posts: 384 City: DFW

its not bashed up at all its a new board

OTT Productions · Posted: Nov 15, 2008 3:58 pm Post subject:

TexasBlazed, ask Sluewcrew he'll know better than anyone. Since he designed the boards

IMHOFF · Frontside 180 Joined: 05 Nov 2008 Posts: 397 City: Orlando

sprised slewcrew hasn't already told ya, jeez sal why u wanna reshape it anyway

TexasBlazed · Frontside 180 Joined: 13 Nov 2008 Posts: 384 City: DFW

thanks i will hit him up an see if he can help. i jus dont wanna mess the board up

IMHOFF, dont worry about it treeeeee

brassmonkey · Posted: Nov 15, 2008 7:05 pm Post subject:

People are all about reshaping rails lately.

SkateWake772 · Ollie Joined: 08 Nov 2008 Posts: 92 City: Orlando

i dont understand the point of reshaping the rails.
do u not like how the board edges?

mr.foonis · Posted: Nov 16, 2008 1:03 am Post subject:

it changes how the board feels/edges and how it sits in the water... but i have no clue how to reshape id just guess really fine grit sandpaper

mojo · Posted: Nov 16, 2008 1:26 am Post subject:

med grit sand paper. i dont understand integ. instructions so im not gonna do it, but i think i'd love it a little lower in the agua

mojo · Posted: Jan 15, 2009 6:53 pm Post subject:

on the integ's do you just sand where the bottom sheet meets the urethane or do you need to go up the ure. some too?