tav ?

bmr712 · Posted: Jun 25, 2008 11:45 am Post subject: tav ?

does it matter the hourse power the tav is rated for..i found one and it said HP: 8 HP (2 Cycle / 4 Cycle)....Does that matter

Montgomery · Backside 180 Joined: 26 Feb 2008 Posts: 976 City: Rogers

I was told you can run up to a 10 hp motor on the tav 30 series which is the one rated up to 8hp

bmr712 · Posted: Jun 25, 2008 12:18 pm Post subject:

Montgomery, i was guna run a 6.5 hp

Montgomery · Backside 180 Joined: 26 Feb 2008 Posts: 976 City: Rogers

is it a 30 series or a 40 series TAV ? 30 series is 3-8 hp. 40 series is 8-18 hp. I was told if it's under 10 hp use the 30 series

bmr712 · Posted: Jun 25, 2008 2:57 pm Post subject:

its a 30 series

Montgomery · Backside 180 Joined: 26 Feb 2008 Posts: 976 City: Rogers

then as long as it's bore size will fit your engines crankshaft which is probably 3/4" then it should work just fine . . . . Is it a 10 tooth or 12 tooth ? You might wanna take that into consideration as well even though you could always change it later if you want

bmr712 · Posted: Jun 25, 2008 3:05 pm Post subject:

Montgomery, im not sure which is better 12?

bmr712 · Posted: Jun 25, 2008 3:12 pm Post subject:

Montgomery, it is a 10

Montgomery · Backside 180 Joined: 26 Feb 2008 Posts: 976 City: Rogers

I'm using the 10/60 setup on my 8hp which is the 10 tooth TAV and a 60 sprocket . . . I think most people are running 12/72 on the 6.5hp motors but I'm not 100% sure http://iwinchglobal.com/winchgallery.html <------ Have you been here ?

Montgomery · Backside 180 Joined: 26 Feb 2008 Posts: 976 City: Rogers

I don't see a problem using the 10 tooth on a 6.5 . . . There are people using 10/72 and 10/60 on a 6.5

bmr712 · Posted: Jun 25, 2008 3:21 pm Post subject:

Montgomery, alright thanks for the help

Montgomery · Backside 180 Joined: 26 Feb 2008 Posts: 976 City: Rogers

anytime