Joined: 28 Nov 2003 Posts: 1085 City: Punta Gorda/Tallahassee
Posted: May 13, 2004 1:13 pm Post subject: Tin rail?
OK, here's the deal. I have a piece of tin (18ft long by 26in wide) and i was wondering if tin slides well. It's left over stuff from when we built our house a while ago. I was thinking of making a little tabletop slide by building a frame with 2x4's or something and then making the top with plywood, then covering that in the tin. Anyone have any experience with that material before?
Yeah it will work just make sure that what ever you fasten it down with isnt sticking up and that the edge arnt some where you might hit them, i made a rail with it for snowboarding and cut my hand on the side pretty good one time.
Joined: 28 Nov 2003 Posts: 1085 City: Punta Gorda/Tallahassee
Posted: May 16, 2004 7:49 pm Post subject:
Yeah, I was planning on making the frame about an inch smaller than the piece and just hammering the edges down into the wood or something. I just wanted to make sure it would slide, thanks.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You can download files in this forum